Before using the
strapping machine, it is necessary to check whether the photocell of the strapping machine is in good condition, whether the reflector is aligned and whether there is dust on it. If it is not aligned, put it in the correct position and remove the dust on it. Whether the screws and nuts of each component are loose, they should be tightened in time. If there is a phenomenon of missing nails and caps, the repair personnel must be notified to deal with them in time. Check whether there is any debris in the belt conveyor, and if it must be removed, blow out the dust in the belt conveyor with compressed air.
Check whether the crankshaft is short of oil. If it is missing, the crankshaft must be oiled by dipping and dripping. Usually, a small stick is dipped in oil and slowly dripped on the shaft. When the belt is slipping, the belt will not be retracted, and the belt will not be tightened. If abnormal phenomena are found during the startup process, such as loud sound, large vibration, peculiar smell, etc., if you cannot find it by yourself, you should stop the automatic strapping machine and call the repair personnel to deal with it, so as to avoid damage to the internal parts. In addition, it also provides the use and maintenance of vacuum packaging machines, binding machines and shrinking machines.
During the production process of the packing belt, due to the influence of the density of the incoming materials, equipment failure, human factors, etc., the specifications of the strapping belt are unstable after it is manufactured. The following cases often occur, such as uneven thickness and uneven width ,rough surface. It makes the phenomenon of not being able to put on the belt, not being able to play the belt tightly, and the cassette tape during the packing process. It directly affects the progress of production and the downtime rate of the packaging group. The usual treatment method above is to first check whether it is the equipment or the strap. When checking and confirming that it is the cause of the strap, if it is found that the thickness is uneven, the width is uneven, etc., the strapping has a quality problem. It is necessary to cut off the unqualified section and not use it. During the trial, if the strap can be hit but not tight, adjust the elastic button on the strapping machine until the strap is adjusted to meet the process standard. allow.
The unstable quality of the strap of the strapping machine will also cause difficulty in feeding the strap, or it may not be able to directly enter the strap, or even cause the phenomenon of jamming. If a roll of tape is mostly not up to the quality standard, try a new bundle with a new one. In production, the cigarette packs run directly over without being taped, or one of them is not. The photocell and reflector should be checked for alignment, and if they are not aligned they should be aligned. If damaged, notify an electrician for replacement. When the cigarette pack reaches the position where it should be marked, it is not to be marked. The treatment method is to check whether the temperature regulator of the soldering iron is in the required temperature position, usually the temperature is 300C. It can be appropriately adjusted between plus and minus 10C according to the temperature of the environment.