Pneumatic baler is a friction welding type baler, which is powered by air source, and welds the interface of PET plastic steel belt by friction and heat fusion of stacked PET plastic steel belt. It has the characteristics of low failure rate, one-key operation, and strong continuous working ability. Do you know how to use the pneumatic strapping tool correctly? Let Zhejiang Best Packaging Technology Co., Ltd take you to find out.
1. Pass the packing tape through or around the packaged object to form two closed loops of upper and lower tapes, with the short end at the bottom and the long end at the top. Hold the upper and lower straps with your left hand.
2. Hold the handle of the baler with the right hand, and lift the tightening motor (cylinder) upward, the front side guide plate and the tightening wheel of the baler are released, and keep this action.
3. Put the upper and lower packing belts into the belt guide groove at the same time, and put the upper belt on the upper layer of the cutter frame, loosen the tightening motor with the right hand, and press the upper and lower two aligned belts by the tensioning wheel. packing tape.
4. Press the gray tightening button of the baler with the right thumb and do not release it until the strap is tightened to an appropriate degree, then release the tightening button. Note: After the strap is tightened, do not force it again frequently.
5. After the packing belt is tightened, press the orange fusion key with the right thumb, hold it for about 3-4 seconds and then release it, the packing belt is automatically locked and cut by the hot melt. Note: If the air pressure is lower than 6 kg, the welding time can be appropriately extended.
6. Press the retract button 1-2 times with the little finger of the right hand, the tightening wheel will automatically loosen, the right hand will hold the tightening motor (cylinder), and pull out the baler to the right, and the packing is completed.
As a purely mechanical strapping and packaging tool, the failure rate and service life of the pneumatic baler depend on standardized operating habits and good daily maintenance. After reading it, I believe that everyone knows how to use the pneumatic baler correctly and properly.
