The situations where the automatic strapping machine
does not enter the belt are:
The PP belt installation method is incorrect, the solution is to reinstall the PP belt correctly
The belt is incorrectly worn, the solution is to re-wear the belt correctly
The induction switch LS-2 is not working properly, the solution is to adjust the contact time
The time setting of T2 tape feeding is not enough, the solution is to check and adjust the T2 tape feeding time
The storage capacity of the PP belt in the storage box is insufficient, the solution is to adjust the storage capacity of the PP belt
The belt of the motor M2 is damaged or the fixing screw of the pulley is loose. The solution is to replace the belt of the baler or the fixed pulley.
Tape feed does not stop
The tongue door with the channel or the bow frame is not reset, the solution is to adjust the spring force or replace the spring
The time of the timer T2 is not set too long, and the solution T2 brings the time.
The contact time of the induction switch LS-2 is incorrect, the solution is to adjust the contact induction time
The belt of the motor M2 is damaged or the pulley is loose, replace the belt or fix the pulley
The above is the analysis and solution of the failure of the forward and backward belt of this strapping machine.